Jump to content

Archived

This topic is now archived and is closed to further replies.

sheilahoff

DMS full width?

By sheilahoff+, in DMS & Legacy Products

Recommended Posts

sheilahoff+    63

sheilahoff
Posted

I'm pretty new to PL and of course to DMS. I'm considering purchasing Reveal. I'm wondering if it can go full width? And I'm wondering in a box layout if it can go edge to edge the way RevSlider does? I love the look of RevSlider but I need a tool that will pull posts by category which it appears Reveal will do for me, right?! Thanks.

Sheila Hoffman | Hoffman Graphics | Seattle

Share this post

Link to post
Share on other sites
Go To Topic Listing DMS & Legacy Products

  • Similar Content

    • imagineutopia
      Reveal unable to exclude catagories?
      By imagineutopia
      hi. I asked about this before and sorry if it was answered and I missed it.
       
      I can't get reveal to exclude categories and its making my site look junky. if all the pictures aren't the same size, then the layout starts getting jacked up.
       
      ideally I'd like them not to be getting jacked up like that just cause an image is 300x300.
       
      but I could work around that is by excluding some categories I don't want to show but I can't get it to exclude.
       
      I've attached some images and arrows for clarity. would love to get this fixed. thanks, John
       
      small image jacking it up:
       
      http://stringchange-images.s3.amazonaws.com/wp-content/uploads/bad1.jpg
       
      starts going over other images:
       
      http://stringchange-images.s3.amazonaws.com/wp-content/uploads/problem.jpg
       
       
      how it should be ideally if image is small as opposed to the content bar rising up and going goofy.
       
      http://stringchange-images.s3.amazonaws.com/wp-content/uploads/decent.jpg
       
       
    • imagineutopia
      reveal not excluding added categories
      By imagineutopia
      hi. I have a reveal running on a site and there's a couple categories I've added to exclude and it doesn't seem to work. they keep showing up.
       
      is this  a know issue or am I doing something wrong? I pecked down the cat IDs and have them in there right. 
       
      thanks,
    • imagineutopia
      reveal not working in post mode
      By imagineutopia
      hi. I have a page I'm trying to use Reveal on but its not wanting to work for me.
       
      When I put a cat ID in for post mode, nothing is coming up, but when its set to work in non post mode its running and looks good.
       
      right now its broke at this link, its at the bottom all flat and dead.   http://www.lynneheffnerferrante.com/about/
       
       
      but here at this link I have it working in regular mode and its working fine. http://www.lynneheffnerferrante.com/delete/

×